Clean Burnout, Precise Control and Ecological Design

Uniform Heat Transfer
Our RBF-Rotating Burnout Furnace distributes the heat uniformly due to the minimal differenee of temperature between the heater surface and the chamber as well as due to the displacement of air caused by the rotation. In this way, all the flasks are heated at the same temperature regardless of distance from the heating coil.

Accurate Temperature
When your burnout furnace is at the temperature of 650 degrees centigrade, open the door and look at the color of the heating coils. If they are orange/red, the temperature is far greater than the indicated temperature.

Therefore, the part of the flask which faces the coil can get badly overheated & the flasks which are near the coils are at higher temperature than the other flasks.

Minimal Heat Loss While Opening The Door
As the door is not wide like normal burnout furnaces, the heat lost is much less and that temperature does not fall much.

Program Memory
4 kinds of different burnout cycles can be memorized on the controller.

Overheat Protection Device Safety For Stones In Flask
The value of precious stones inside the furnace is beyond comparison with the value of the furnace. RBF13's overheat protection device on the front panel can prevent the precious stones safely from overheating. Should the temperature exceed the setting value, the power is immediately shut off.

Measures For Power Failure
On power failure during burnout cycle time under automatic burnout mode, present burnout STEP is memorized. And when power is recovered, the burnout cycle can be automatically restored and started from the step number where power failure occurred.