Slide background

VCC 20A

- Full auto mode, semi-auto mode, and manual mode are available.

- Control by digital touch panel.

- Stepless control of rotation speed and initial spin-up

- High performance servo-motor is built in.

- Double swing arm (pat.) is adopted.

VACUUM CENTRIFUGAL CASTING MACHINE VCC 20A

Slide background

Automatic mode (full-auto, semi-auto) is operable
Digital touch panel is adopted

Operator can determine casting timing freely in the case of manual mode.Different from the controversial machine, various settings can be performed on the touch panel. Further, initial spin-up speed of rotation has been improved.

In the case of automatic mode, automatic gas substitution is possible up to 3 times. Different from the controversial machine, the semi-auto mode is available, and also the full-auto-mode can operate automatically to the finish of casting (rotation).

Slide background

Various settings can be done on the touch panel | Alarms are displayed separately from errors

Setting change that was not possible by the controversial machine or required complicated procedures is now possible on the touch panel. Casting of better quality more closer to you ideal design can be realized.

The alarm indicators are displayed separately from the error indicators. As these indications are turned on one by one, productivity is powered. Operator's stress can be reduced.

Slide background

Stepless control of rotation speed and initial spin speed
New type high performance servo-motor

Initial spin-up time required to achieve final rotation speed can be set freely*.
*The fastest initial spin-up speed is 500 rpm by 0.1 sec.
As three types of S-curves are preset, rotation conditions can be set almost steplessly.

Initial spin-up speed of this machine is 500 rpm by 0.1 sec.(The conventional machine was 500 rpm by 0.2 sec.)
By this, the machine can process more metals.

Descending time of the coil is greatly shortened to 40 msec. (Conventional machine was 200 msec.)
So, higher precision casting is possible.

Slide background

Thermal control with high accuracy is realized

Thermal control with high accuracy is possible by the optical thermal controller.

In addition to heating control by the temperature controller, the machine is newly equipped with the heat power control dial, so upper limit output can be adjusted steplessly.

Slide background

Double Swing Arm

By the originally developed Yasui "Double Swing Arm" (Japan Patent No. 3178748), the molten metal can be poured into the mold straightly without loss. Improvement of filling efficiency, improvement of metal density, and substantial reduction of metal loss has been realized.


VCC – Vacuum Centrifugal Casting Machine for Platinum

For the Best Casting of Platinum.

Advantages of Altima Smart Wax System

Our Vacuum Centrifugal Casting Machine – VCC is specially designed for casting Platinum only.
Any centrifugal high temperature casting machine can cast platinum.

  • Full auto mode – semi auto –and manual mode operation
  • Smooth surface and controlled loss
  • Good casting with filigree,light weight and heavy pieces
  • High performance servo motor
  • Double swing arm
  • Touch panel for easy setting and operational cont
  • Thermal control with high accuracy
  • Self diagnosis
Check out our long-run VCC

  • The best of platinum casting result is to be obtained with well filling efficiency of metal by originally developed “Double Swing Arm” of the Yasui Casting Machine.
  • Revolutions per minute (r.p.m.) and acceleration of the “Double Swing Arm” right after starting the Casting Machine are so easy to control automatically with repeating consistency.
  • Accurate timing for casting can be achieved by Optical Thermal Control assuring thermal control with high accuracy.
VCC – Vacuum Centrifugal Casting Machine for Platinum